Electric and Electronic spare parts

Manufacturers

Viewed products

New products

Napier EJ3815 turbocharger speed probe, Jaquet DSH 1840.01 PHV

Napier-EJ3815

New product

Napier EJ3815 turbocharger speed probe

More details

Price on request

or call +47 908 92 500

Data sheet

Manufacturer Napier Turbochargers
Model Jaquet DSH 1840.01 PHV
Manufacturers part number Napier EJ3815 / Jaquet DSH1840.01 PHV
Alternative part number EJ3815 / DSH184001 / DSH1840.01
Other Inductive HF speed sensor with amplifier, made by Jaquet, CE, marking 3110. Square-wave push-pull output, 0.1 Hz - 20 kHz, air gap 0.2-4 mm, M18 x 1.5 housing, PTFE shielded cable 2 m, IP67, -30 to +125 °C, metal Lemo connector
Amps No load 12 mA at 12 VDC / Output max 25 mA
Volt Supply 10-30 VDC

More info

Napier EJ3815 – turbocharger speed probe (HF speed sensor)

Napier approved speed measuring device for the air-cooled axial turbochargers, 7 and 8 series: inductive HF sensor with built-in amplifier, Jaquet type DSH 1840. The sensor detects the passing aluminium or titanium compressor vanes and gives a square-wave output signal. The air gap does not influence the calibration.

New, in stock.

EJ3815 has a metal Lemo connector. EX3816 is the same probe with a Bendix (Amphenol) connector.

  • Napier part no.: EJ3815
  • Sensor: Jaquet DSH1840.01 PHV (marking on the unit), inductive HF sensor with amplifier
  • Manufacturer of the sensor: Jaquet, CE marked
  • Power supply: 10-30 V DC, max ripple 25 mVpp, max 100 mA
  • Current consumption: 12 mA at 12 V DC without load
  • Output: square wave, push-pull, max load 25 mA (source or sink), short-circuit protected up to 25 mA
  • Frequency range: 0.1 Hz – 20 kHz
  • Air gap: 0.2 – 4.0 mm (aluminium blade)
  • Temperature: sensor body -30 to +125 °C, cable rated 200 °C
  • Housing: aluminium alloy, black anodised, M18 x 1.5, length 50 mm
  • Cable: PTFE 3-core 3 x 0.22 mm² (AWG24), shielded, 2 m
  • Protection: IP67
  • Connector: Lemo, metal
  • Lemo wiring (looking towards the sensor head, pre-wired side, locating lug at top): output signal top left, supply 10-30 V top right, ground (cable shield) bottom left, 0 V bottom right
  • Screening: terminate the cable screen at the instrument panel via 0 V, not to power earth

Pulses per revolution (compressor wheel designation on the turbocharger nameplate)

  • G: 9 pulses – Napier 297, 357, 458 and 558
  • GS: 13 pulses – Napier 297, 357, 458 and 558
  • H: 13 pulses – Napier 298
  • J: 11 pulses – Napier 397, 307